Click to enlarge

PCMc SERIES

Phase change type air dryer, it only runs when it's needed, so the cost of electricity is 1/10

No more refrigeration dryer that runs all the time!
This PCM technology harnesses the latent heat occurs when PCM converts solid to liquid or liquid to solid, which automatically triggers the refrigeration compressor to switch ON of OFF according to varying compressed air heat loads.

Request a Quote Request Service, Parts or Support

Product Features

Unique product design

Adapted Phase Change Material PCM (Patented)
Stainless steel brazed plate heat exchanger with PCM filled in
Automatically triggers refrigeration compressor to switch ON or OFF according to varying compressed air heat loads

Great Energy Efficiency

Up to 99% energy saving with the lowest cost
Shortest period of return of investment

No Loss Drain

Electrostatic capacity sensor
Zero loss of compressed air when condensate water is discharged
Automatically switch to timer mode at malfunction

Oil Removal to Provide Virtually Oil Free Air

Integrated Cold Coalescing oil removal filter
99.8% oil removal efficiency

Heat Exchanger 5-year Warranty Program

When used with NGF filter installed upstream and filter element replacement had been in accordance with recommended maintenance
Heat Exchanger replacement is confined to its leakage or blockage problem

Operating Fundamental

Phase change in PCM dryer

When a refrigeration compressor and condenser fan are running, the cold refrigerant in the chiller (evaporator) cools the liquid Phase Change Material(PCM) and it gradually freezes.
When a PCM is sufficiently cooled and frozen, the refrigeration compressor and condenser fan stop.
The compressed air is continuously cooled by the PCM while the refrigeration compressor is inactive. No power is consumed during this period.
The PCM gradually melts as it adsorbs heat from the compressed air, and when fully melted, the refrigeration compressor and condenser fan resume to cool down the PCM.

How it works.

Compressed air saturated with water vapour enters the stainless steel brazed air-to-air heat exchanger, is pre-cooled by the outgoing chilled air, and then directed to the stainless steel brazed plate PCM-to-air heat exchanger (evaporator) where it is further cooled by the Phase Change Material (PCM).
As the air is cooled, water vapour condenses into liquid droplets which are then removed by high efficiency external moisture separator with No Loss Drain.
Then aerosol and oil mist condensed from oil vapour are removed by high efficiency external oil filter with a No Loss Drain.
Chilled air returns through air-to-air heat exchanger (re-heater) where it is reaheated before exiting the dryer. This is to prevent external sweating of piping when clean and dry compressed air travels to point of use.